Spanish Edition

To Home Page

  Email

FRP-NC is a non-CFC semi-permanent, polymer release coating ideally suited for molding reinforced plastic and cultured marble parts. It is a unique
release interface, specifically formulated for polyester resins, which chemically bonds to the mold surface forming a micro-thin release film.
Mold Surface Temperature Range: Room temperature (60-105F). Curing Time: 15-20 minutes after final coat. Benefits: Multiple release
•High-gloss parts •Considerable labor savings over wax •No chlorinated solvents •Eliminates cleaning and buffing.
Application: Remove all traces of waxes, sealers, rubbing compounds or other agents, and apply with a clean, lint-free cloth. Wait 1520 seconds
before gently wiping with a second cloth. Changes in temperature will affect solvent dry time. No hard rubbing is required. Apply a maximum of six
coats initially, then a single coat for the first two or three releases, to condition the mold. Use with Frekote FMS.700-NC Is a non-CFC, semi-permanent, multiple release polymer resin which effectively releases all polymer resins. Versatile agent that provides
slip where mold geometry problems are encountered. It cures at room temperature to give a high-gloss finish to molded parts.
Mold Surface Temperature Range: Up to 275F (135C)
Curing Time: 15-20 minutes after final coat @ room temperature. Benefits: •Superior multiple release performance •High slip and high gloss •No
chlorinated solvents •Versatile: releases most polymers.
Application: Can be applied to mold surfaces up to 275F (135C) by spraying, brushing, or wiping with a clean lint-free cloth. Initially apply two or
three coats, allowing up to 15 minutes after each application for complete solvent evaporation. Molding should not be attempted until the film feels
dry, not tacky, to the touch; approximately 15 minutes.

770-NC is a non-CFC, semi-permanent, multiple release polymer resin which effectively releases epoxies, polyesters, and all other common
thermosetting resins. Dries and cures very rapidly at room temperature to give a high-slip film capable of maximum release performance.
Mold Surface Temperature Range: Room temperature (60F)-140F (60C) Curing Time: 5- 10 minutes after final coat at 80F Benefits: •Fast-dry •Fast
cure •High gloss and high slip •Versatile: releases most polymers •No mold build-up •Reduced odor. Application: Apply to mold surfaces by spraying,
brushing, or wiping with a clean, lint-free, cotton cloth. When spraying, ensure a dryair source or airless spray system. Only a thin, wet film is
required. Apply up to three coats; enhance performance by recoating once after the first few initial pulls. Touch up as necessary.

Cultured marble and reinforced fiberglass molders from around the world rely on superior results from the Frekote® line of products. Frekote offers
benefits that no other mold release system on the market can match. You'll achieve easy multiple releases between applications, as well as
consistent high gloss cosmetics. Frekote products are non-transf erring, which means you can immediately paint or bond your parts after they are
released. And because there's no build-up, cleaning requirements are eliminated saving you labor and material costs while achieving superior results.
If you're still using a wax release agent, consider this: one Frekote customer reduced labor and material costs 90% when they switched to Frekote
from wax, and they obtained a better finish too. Put Frekote to work for you, you'll see the highest release quality with the lowest labor investment of
any mold release system available today.

Back to Mold Release Agents Menu

© Copyright 1998-2008 On-Hand Adhesives, Inc All rights reserved
1-800-323-5158
                        Last modified: January 09, 2008