|
 
You may print this page for your file
Hysol ® 7480
Hot Melt Adhesive
Description
Hysol SprayPac™ 7480 is a polyamide hot melt formulation for spray application using the Hysol 4210 SprayTool™. Hysol 7480 combines long open time, and good heat resistance. SprayPac 7480 bonds foams, fabrics, wood and other materials.
Typical Properties
Test Method
Softening Point R B, °F 250 ASTM E28
Viscosity @ 350°F centipoise 3,900 ASTM 3236
Heat Resisitance, pine, 2lb, °F 211 ASTM D4498
Open Time On Foam, Seconds 50
Open Time on Kraft Paper, Seconds 80
Application Temperature, °F 400
Application
Best results are achieved when sprayed 3 - 9" above the substrate with the Hysol 4210 SprayTool™ using thermostat number EST003.
Availability
Polyshot Cartridges packaged in 25lbs pails.
Technical Consultation Service
Our technical staff and representative are ready to assist in solving any special bonding requirements. You are invited to take advantage of our extensive experience, laboratory services and trained field service staff. Call
800.323.5158 now and let us help you with your adhesive needs.
DISCLAIMER: The information supplied in this document is for guidance only and should not be construed as a warranty. All implied warranties
are expressly disclaimed. Including without limitation any warranty of merchantability and fitness for use: All users of the materials are responsible
for assuring that it is suitable for their needs, environment and use. All data is subject to change as Dexter deems appropriate.
Users should review the Material Safety Data Sheet (MSDS) and product label for the material to determine possible health hazards, appropriate
engineering controls and precautions to be observed in using the material. Copies of the MSDS and label are available upon request.
For
more information or to order contact the Glu Guru™ at 1-800-323-5158
or Contact
Us
| 
The Glu
Guru™
Adhesive Tech Center
