omnIFIT 1350 is a general purpose threadlocking adhesive for nuts, bolts and screws. Its medium strength perits easy disassembly. It can be used for locking or sealing hydraulic and pneumatic fittings and low strength bearing mountings. Military Spec: MIL-S-46163 Type II, Grade N.

omniFIT 1550 is a high strength adhesive for threaded fasteners and studs up to one inch in diameter. On threaded fasteners it is ideal for high load or high vibration applications.
Military Spec: MIL-S-46163 Type I, Grade K

omniFIT1560 is a high-strength adhesive for locking threaded fasteners that must withstand severe conditions. It's designed to prevent fasteners from loosening under high shock or severe temperature environments. Military Spec: MIL-S-46163 Type II, Grade 0

omniFIT 1570 is a high-strength, non-migrating adhesive for threaded fasteners and studs over one inch in diameter. It has all the properties of omniFIT 1550 plus a higher viscosity for added gap filling requirements of larger threads. Military Spec: MIL-S-46163 Type I, Grade L

omniFIT 1710 is a high-strength penetrating adhesive for locking preassembled parts. Its wicking action allows it to be applied after parts are assembled. Commonly used for sealing pinhole leaks in welded, soldered or brazed assemblies. Military Spec: MIL-S-46163 Type III, Grade R

omniFIT 1730 is a general purpose retaining compound used for mounting or retaining bearings, gears, pulleys and rotors Especially useful for press-fit parts.Military Spec: MIL-R-46082B Type I

omniFITI 1750 is a high strength, high-temperature retaining compound used for mounting and retaining cylindrical parts. Its medium viscosity gives good flow control and prevents the adhesive from being drawn into unwanted areas. Military Spec: MIL-R-46082B Type II

omniFIT1780 is a high-strength adhesive for locking and retaining bearings, gears and pulleys. It is also useful for mounting sleeves, rotors and bushings.Military Spec: MIL-R-46082B Type III

omniFIT 1790 is a high viscosity, non-migrating retaining compound for uses requiring maximum gap filling. It's thixotropic properties also allow it to be used on worn assemblies as a quick repair solution.

omniFIT INSTANT GASKET 10 is a low-strength adhesive used to seal flanges, pipes, pumps, fittings or housings where easy disassembly is important.

omniFIT INSTANT GASKET 20 is a high-strength adhesive suitable for most gasketing applications. It seals flanges or dresses conventional gaskets where fast setting, gap-filling or structural integrity is required.